Application Engineer, WuXi, Jiangsu, China (JB# APP001)
Responsibility
1. Assist the development of wireless sensor network product in different areas.
2. Understand the requirements of customers and design the suitable solutions.
3. Provide the introduction and technical support to the customers.
4. Writing the application sheets and product guide.
Requirements
1． BS or higher in Computer Science，Communication, Electronics,
Control or other related disciplines.
2． 1 year above project experience.
3． Knowledge on wireless communication protocols, e.g. 802.15.4,
Zigbee, GPRS, WiFi etc.
4． Knowledge on embedded system design, familiar with various data
interface, e.g. RS232, RS485, CAN-Bus, ProfiBus etc.
5. Good reading and writing skills in English.
6. Good communication skill.
7． With strong responsibility, self-motivated, be able to work under
pressure and challenges.
8． Team spirit.
System Engineer, embedded wireless system, WuXi,Jiangsu, China （JB# SYS001)
Requirements:
3+ experiences with embedded software development and IEEE 802.15.4 or other wireless technologies. M.S.E.E /M.S.C.S preferred. Experiences with MSP430 and/or 8051 MCU programming. Wireless sensor network experiences are desired but not required.
Firmware Engineer, WuXi, Jiangsu, China （2 openings, JB# FIR00X)
Responsibilities
1. Perform software design, coding, and testing on low power embedded wireless communication devices.
2. Perform network stack development.
3. Develop specifications and design documentation.
4. Ability to drive a project from concept to full production ramp.
5. Ability to work with technical management, turning conceptual requirements into specific designs.
Requirements:
1.Bachelor degree (or Master) in Electrical or Computer Engineering from an accredited university.
2.3+ years of experience in embedded software development.
3.3+ years experience developing network communication stacks.
4.Must be familiar with at least one MCU architecture, for example, 8051, MSP430, or ARM
5.Experience with wireless protocols (Bluetooth, 802.15.4, etc.) desired
6.A highly motivated individual with an ability to “get it done” on time and within budget.
7.Entrepreneurial spirit and takes pride in what they do.
8.A team player, with a strong sense of project “ownership”.
9.Desire to provide design alternatives and contribute to the definition of project requirements
10.Attention to detail and follow up
Hardware Engineer, WuXi, Jiangsu (JB# HAR001)
Responsibilities
1. Design PCB based on reference design.
2. Test and bring up PCB.
3. Ability to drive a project from concept to full production ramp.
4. Ability to work with technical management, turning conceptual requirements into specific designs.
Requirements:
1.Bachelor degree (or Master) in Electrical or Computer Engineering from an accredited university.
2.2+ years of experiences in PCB design. 1+ years experiences with RF matching circuits and/or antenna designs.
3.Familiar with a CAD and PCB layout tools, for example, Altium Design.
4.Familiar with hardware tools such as Oscilloscope or Logic Analyzer.
5.A highly motivated individual with an ability to “get it done” on time and within budget.
6.Entrepreneurial spirit and takes pride in what they do. A team player, with a strong sense of project “ownership”. Attention to detail and follow up.
